Safely6ft.com™ carpet graphics should be applied to clean and dry carpet with a short nap and a tight weave containing minimal texture.
Ambient temperature as well as surface temperature must be between 40˚F
to 90˚F. We recommend acclimating the graphics to the same application
temperature for a few hours before beginning the application process. Use
the supplied tape measure to install the floor graphics 6ft apart.
The carpet should be clean, free of debris and oils and dry.
Lift the upper edge of the liner and fold back approximate 8-12" down one edge, depending on the size of the graphics.
Carefully position your Safely6ft.com™ graphic so that it is properly aligned, then press exposed edge in place using light pressure.
Using your hand or supplied soft plastic squeegee, lightly press the film
in place.
Working from the top of the graphic to the bottom, continue by peeling away
more of the liner and applying light pressure to the film. Continue in this
manner until the liner is completely removed and the graphic is in place.
Using your hand or supplied soft plastic squeegee, from center to all edges
carefully push out any excess air bubbles. Finally, apply firm pressure to
assure adhesion. Full tack will be achieved in 24-48 hours.